Tariff configuration: "Connection Power" filter now possible in 1 kW steps

The "Connection Power" filter, which could previously only be configured in 10 kW steps, can now be defined in single kW steps. This allows a seamless configuration for corresponding cost rates depending on the connection power.

The "Connection Power" filter is available in the be.ENERGISED tariff configuration for the price configuration Current type, CPO (Roaming) and Operator in EMP sales tariffs (including eMSP.OPERATIONS tariffs).

As mentioned above, the purpose of this filter is to allow you to define ranges of maximum connection power of connectors, for which corresponding cost rates will be applied.

In the price configurations mentioned above, you have the option to select the "Connection Power" item in the "Apply further filter" field. This brings up a slider that allows you to specify the minimum and maximum connection power to which the selected cost rate will then apply.

The selection of the area is set in 1 kW steps. We still have to point out that overlapping application areas are not prevented by the system. Therefore, we expressly advise against configuring such.

More information about the tariff configuration can be found in this article.